How long will a 100Ah battery last with a 200W load?

Short answer

A 200 W AC load through a 90% inverter runs about 4.6 hours (4 h 36 min) on a 100Ah LiFePO4 battery used to 80%. On a 12 V 100Ah lead-acid used to 50% it is about 2.7 hours on paper and about 2.1 hours once the Peukert correction for its higher current is applied.

How to work it out

100 Ah × 12.8 V × 80% usable = 1,024 Wh
200 W ÷ 90% inverter = 222.2 W average
1,024 Wh ÷ 222.2 W = 4.6 hours (4 h 36 min)

Two hundred watts is a TV and a laptop together, a small blender, or a box fan on high with lights. It is a useful middle figure for evenings in a van or a power cut.

Adjust for your project

More options: DoD · Inverter eff. · Duty …

Usable depth of discharge (optional)

Blank uses 80% for LiFePO4 and 50% for lead-acid. Check your battery’s data sheet.

Inverter efficiency

Victron puts modern inverters above 90%.

Share of the time the load is on

For anything on a thermostat. A 12 V compressor fridge runs roughly 25–50% of the time (Victron’s example); a household fridge about a third (Virginia Cooperative Extension).

Inverter idle (no-load) draw, W (optional)

What the inverter uses just being on, all the time it is on. It matters most for small loads left running 24/7 — a CPAP, Starlink, a fridge.

Coldest battery temperature

°F

Batteries hold less when cold: Victron gives about 80% for LiFePO4 at 32 °F (0 °C) and 50% at −4 °F (−20 °C); lead-acid about 86% at 32 °F. LiFePO4 must not be charged below 41 °F (5 °C) unless it is self-heating.

Runtime4.6 hours

In hours and minutes: 4 h 36 min
Usable energy: 1,024 Wh
Average draw from the battery: 222.2 W
Battery current while running: 17.4 A

For this job · affiliate link

Battery monitor with shuntA shunt battery monitor shows real amp-hours used, so you know how much of this runtime is left without guessing from voltage.

View on Amazon

Runtime at other loads

Runtime at other loads
Load	Runtime	Battery current while running
25	36.9 hours	2.2 A
50	18.4 hours	4.3 A
100	9.2 hours	8.7 A
200	4.6 hours	17.4 A
500	1.8 hours	43.4 A
1000	0.9 hours	86.8 A
2000	0.5 hours	173.6 A

What to know about a 200 W load

On DC it lasts longer. The same 200 W straight from the battery — 12 V appliances, no inverter — runs about 5.1 hours because there is no inverter loss.
The current is modest. About 17 A at 12.8 V is gentle on any 100 Ah battery and well inside typical BMS limits.
Lead-acid at 50%. A 100 Ah lead-acid battery has about 600 Wh to give if you want it to last, so 200 W through an inverter is about 2.7 hours on paper — about 2.1 hours after the Peukert correction for an 18.5 A draw.
Mix it like real life. An evening of 200 W for 3 hours plus a 25 W fridge all day is about 1.27 kWh — more than one 100 Ah battery holds usable. The solar load calculator adds it up.

Heavier loads are on how long a 100Ah battery lasts with a 1000W inverter; lighter, all-night ones on how long a 100Ah battery runs a CPAP.

Different size? Use the full Battery Runtime Calculator.

What you’ll need

12 V 100 Ah LiFePO4 batteryPremium price
About 1.28 kWh rated in a box roughly the size of a group 24–31 lead-acid battery at around half the weight. Check the BMS discharge limit and whether it can charge below freezing.
See options on Amazon (opens in a new tab)
Battery monitor with shuntMid-range price
Counts amp-hours in and out, so you see true state of charge instead of guessing from voltage — which barely moves on a LiFePO4 battery until it is nearly empty.
See options on Amazon (opens in a new tab)
Pure sine wave inverter, 1000 WMid-range price
Enough for a CPAP, laptop, TV and small appliances. Pure sine is the safe choice for anything with a motor or sensitive electronics.
See options on Amazon (opens in a new tab)

As an Amazon Associate we earn from qualifying purchases. Links to products are affiliate links — they cost you nothing extra and help keep these calculators free.

Frequently asked questions

How long will a 100Ah battery last with a 200W DC load?

About 5.1 hours (5 h 7 min).

How long will a 100Ah battery last with a 300W load?

About 3.1 hours (3 h 4 min) through a 90% inverter.

How long will a 100Ah battery last with a 100W load?

About 9.2 hours (9 h 13 min) through a 90% inverter.

Other common sizes

How long a 100Ah battery runs a fridge — 41 hours — a 12 V compressor fridge (50 W, on half the time) on 100Ah LiFePO4
How long a 100Ah battery lasts with a 1000W inverter — 55 min at full load (12.8 V LiFePO4)
How long a 200Ah battery lasts with a 2000W inverter — 55 min at full load (12.8 V LiFePO4)
How long a 100Ah battery runs a CPAP — 15.4 hours at 60 W (LiFePO4, via inverter)

Sources

Victron Energy — Lithium Battery Smart manual, technical data (opens in a new tab) — LiFePO4 12.8 V: cycle life 2,500 at 80% DoD, 3,000 at 70%, 5,000 at 50% (to 80% of capacity); 92% round-trip efficiency; 12.8 V 100 Ah: recommended continuous discharge ≤100 A (1C), maximum 200 A; capacity about 20% lower at 0 °C; charge only between +5 °C and +50 °C.
Trojan Battery — Technical support FAQs (opens in a new tab) — “We generally recommend a discharge of 20 to 50% of the battery’s rated capacity even though the battery is capable of being cycled to 80%”; 20-hour and 100-hour ratings; freezing points by state of charge.
Trojan Battery — 27TMX data sheet (opens in a new tab) — Group 27 flooded: 85 Ah (5-hr), 97 Ah (10-hr), 105 Ah (20-hr), 117 Ah (100-hr); state of charge vs open-circuit voltage table; charger settings.
Victron Energy — Energy Unlimited (book) (opens in a new tab) — Lead-acid charge efficiency 80–95% (85% suggested as a starting value); battery energy efficiency about 75% for full cycles, about 89% in partial state of charge; inverter efficiencies above 90%.
Champion Power Equipment — Generator Wattage Chart (opens in a new tab) — Typical running and starting watts for household, RV and job-site appliances (a manufacturer’s planning chart — your nameplate wins).